12-03-2014 02:22 AM
I'm pretty new with Aruba Networks but i've managed to setup an Instant cluster of 12 AP103 nodes.
I've also setup radius authentication for the admin users to login.
However, 1 access point is complaining about the authentication server being down: Authentication Server yyy with ip x.x.x.x is down.
Configuration is all the same so what could be wrong ?
Also, in the troubleshooting process i tried to ssh to the AP, but i can't ssh to any AP nor the virtual controller ip address.
When i connect i get this :
login as: user@domain
Aiee, segfault! You should probably report this as a bug to the developer
Also, i removed 1 access point from the instant configuration to keep as spare.
Now the fault stays about the removed access point being down while it has been removed from the configuration ?
We run version 188.8.131.52-184.108.40.206_46936.
- What could be wrong why i can't SSH, i've enabled the terminal option in the GUI ?
- What could i use to trouble shoot that single authentication server issue ?
- Why does a removed access point result in a fault ?
Many thanks !
Solved! Go to Solution.
12-03-2014 02:44 AM
That is very strange. I would open a TAC case.
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
Validated Reference Design Guides : http://community.arubanetworks.com/t5/Validated-Reference-Design/tkb-p/Aruba-VRDs
12-03-2014 05:40 AM - edited 12-03-2014 05:40 AM
I managed to solve the radius issue by removing the access point from the config, reboot it and rejoining it.
The ssh issue was solved by using domain\username in stead of username@domain.
Only remaining issue is when an access point is removed it keeps displaying it as fault.
I've found on the forum the entire cluster needs to be rebooted for the error to dissappear but i haven't been able to try that yet.
I'll try to contact support.