Controller Based WLANs

How do I erase the flash configurations on the AP for mesh and remote APs?

Aruba Employee

Product and Software: This article applies to remote APs and mesh points with ArubaOS 3.3.1.0 and later. RAP-5WN or RAP-2WG are not included.

 

 

First, get the console of the AP, reboot the AP, stop the boot process, and get into the apboot> prompt.

 

 

Aruba AP-60 and AP-70 Series Models

 

To erase the mesh configuration, issue this command:

 

apboot> flash erase 0xbfc40000 0xbfc5ffff

 

To erase the remote AP configuration, issue this command:

 

apboot> flash erase 0xbfc60000 0xbfc6ffff

 

Aruba AP-120 Series Models

 

To erase the mesh configuration, issue this command:

 

apboot> erase 0xbfb20000 0xbfb3ffff

 

To erase the remote AP configuration, issue this command:

 

apboot> erase 0xbfb60000 0xbfb7ffff

 

After you issue the command and boot the AP, it can be reprovisioned by the Aruba controller.

Version history
Revision #:
1 of 1
Last update:
‎06-30-2014 04:59 PM
Updated by:
 
Labels (1)
Contributors
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.