Controllerless Networks

Reply
Occasional Contributor II
Posts: 10
Registered: ‎01-28-2015

Instant VC Config

I am getting a little confused with a new IAP install I am working on. I have configured one of my IAP as the master and configed the VC IP address, however the IAP I chose for the VC is never actually the master. All others APs have the Master option disabled.

 

Any thoughts?

Guru Elite
Posts: 21,269
Registered: ‎03-29-2007

Re: Instant VC Config

When you say the one you chose as the master, do  you mean you set it as the preferred master?  http://www.arubanetworks.com/techdocs/Instant_41_Mobile/Advanced/Content/UG_files/CustomizeIAPParams/Master_Election_Protocol.htm



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 10
Registered: ‎01-28-2015

Re: Instant VC Config

Yes I configured it as the preferred master.

Guru Elite
Posts: 21,269
Registered: ‎03-29-2007

Re: Instant VC Config

The AP that is the VC at the time should have the asterisk right after its name.  Are you saying that this is not the case after setting it to the preferred master?

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 10
Registered: ‎01-28-2015

Re: Instant VC Config

Guru Elite
Posts: 21,269
Registered: ‎03-29-2007

Re: Instant VC Config

I would run:

 

(Instant AP)# show election statistics

(Instant AP)# show summary support

 

On both of those APs commandline to determine what is going on.

 

Also collect "show log system" from both APs (1 and 7).

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: