Controllerless Networks

Reply
Frequent Contributor II

enable only 80Mhz channels and specific MCS

Hello,

I'm using Aruba Intant 225 AP and for testing purpose I would know if there is some way to enable only 80Mhz channel bonding on 5GHz band and how to do it.

 

I would also know if I can configure specific MCS on 5Ghz, it's for testing purpose.

 

Thank you

Guru Elite

Re: enable only 80Mhz channels and specific MCS

All wifi needs legacy rates for management traffic, so you cannot exclude them, no.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor II

Re: enable only 80Mhz channels and specific MCS

Hi joseph,

 

I'm using IAP 225 with instant version 6.4.3.4 and I have seen that this release supports MCS 0-9 configuration for each stream, with commands:

   supported-mcs-set and vht-support-mcs-map  in a wlan profile

The question is that I have configured MCS 2 or 3 for each one of three streams, but I don't see any changes at wlan profile configuration, the command is not shown at config.

Is there some way to check for each stream which valid MCS is available??.

Could also check is a client 11ac is using 20, 40 or 80 Mhz channel??.

 

Thank you

 

Guru Elite

Re: enable only 80Mhz channels and specific MCS

I am not aware of how to configure a specific mcs on instant.  "show ap association" shows the client capability:  http://www.arubanetworks.com/techdocs/Instant_42_WebHelp/InstantWebHelp.htm?_ga=1.43038629.1615771646.1440445030#CLI_commands/show%20ap%20association.htm?Highlight=show%20ap%20association

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: