i will be blunt, how should i set this up? i mean nothing fancy but just get it working..
setup.
6 Aruba IAP-225's all updated to the latest firmware.
Cisco Catalyst 3750
CPPM (will take care of this later)
3 SSID ( Internal only Employees), (External only for guest), and one for managers who have all access and point them to existing DHCP server.
i already have the IAPs setup working with a virtual controller on the cisco switch.
LACP ether/port channels to each iap because of the dual connections.
these are VLAN 40, 192.168.40.x
switchport mode access
I know how to create the SSID's and have. How do i go about making sure those SSID get on the correct vlans? Internal is Vlan 50 192.168.50.x, External is Vlan 51 192.168.51.x, Management is vlan 53 192.168.53.x (these are trunk vlans)
Do i need to make them the dot1q encapsulation??
do i associate those vlans with the port groups?
Is there a way for those vlans to see the existing dhcp server with scopes for those ip ranges i have already created? (this is with ip helper address in the vlan correct??)
Sorry if this is a lot but i have not done networking in a long time and not done enterprise grade wireless ever. Got stuck on this project and i need some major major help
#AP225