@HammelBrau wrote:
Thanks CJoseph!
Just to make sure I'm doing what you recommend:
On virtual controller, go to RF (in top right) and set (in advanced options > ARM) min/max at 12/18 (min 12, max 18).
Then, for each (of two) SSID, edit those and, in advanced options > WLAN settings, set 2.4 GHz at min 11, max (54???). Oprions for 5 GHZ is 12 (not 11) also max is 54. I assume do this for each of the two SSID (one corporate, one for guiest).
Thanks again for your input...
I was trying to get a screenshot, but i cannot. Basically if you edit your WLAN and go to Advanced you will see:
Basic rates 1,2 checked
Transmit Rates 1,2,5,11......54 checked.
On basic rates uncheck 1 and 2 and only check 11
On transmit rates uncheck all rates lower than 11 and leave the rest checked.
Only do it for one SSID for now to test. Start a constant ping and attempt to roam from AP to AP, and see if things have improved.
The client really controls when it will roam or not, so all we can do is try to influence that. Above, we are limiting the rates at which a client can connect so that it would roam sooner. If it does not work, you can try lowering the rates, by enabling the 9, basic rate and the 9 transmit rate and trying again... This is definitely trial and error and wil not work in every environment....