Monitoring, Management & Location Tracking

How to view Interfering Devices in VisualRF
Requirement:

How to view Interfering Devices in VisualRF



Solution:

In AMP 8.2 by default we do not show Interfering devices in VisualRF.

To enable the option, run the below command in AMP CLI :

# dbc "update seas_config set send_interferers_to_vrf =1;"



Configuration:

AMP 8.2.X, VisualRf should be turned ON.



Verification

Navigate to VisualRF > Floor plans. Select to view 'Interfering Devices'

Version history
Revision #:
2 of 2
Last update:
‎05-26-2016 05:55 PM
Updated by:
 
Labels (1)
Contributors
Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.