Network Management

last person joined: 4 days ago 

Keep an informative eye on your network with HPE Aruba Networking network management solutions
Back to discussions
Expand all | Collapse all

Airwave auto discover for Aruba switches

This thread has been viewed 2 times

  • 1.  Airwave auto discover for Aruba switches

    Posted Jul 10, 2018 04:27 AM

    Hi,

     

    We have instaled AirWave 8.2.1.6 recently and trying to auto discover the Aruba switches but not happening.

    We can add manually the same Aruba switch successfully.

    The switch model is Aruba 2530 24G POE+.

    In AMP device setup--> communications page we have configured SNMP parameters and also the same parameters in Aruba switche as well.

    Can any one help please...

     

    Thanks,

    Ashok 



  • 2.  RE: Airwave auto discover for Aruba switches

    EMPLOYEE
    Posted Jul 10, 2018 10:32 AM

    Did you also set up / configure the discovery scan?  This is done on the Device Setup -> Discovery Scan page.  You add a network, then add scan creds, and then add scan set (combo of the networks and creds to use in the network scan).



  • 3.  RE: Airwave auto discover for Aruba switches

    EMPLOYEE
    Posted Jul 10, 2018 10:44 AM

    Ashok,

     

    You have to add new scan set for switch to auto discover in DeviceSetup>Discover page

    communitry.PNG



  • 4.  RE: Airwave auto discover for Aruba switches
    Best Answer

    Posted Jul 13, 2018 02:41 AM

    Hi,

    Sorry for the late response.

    I have opned a TAC with Aruba and have come to know that the Auto discovery will work only when the device management interfaces are in VLAN 1 which is default.

    TAC asked us to add all the devices manually.

     

    Thanks and regards,

    Ashok Kumar Sunkara.

     



  • 5.  RE: Airwave auto discover for Aruba switches

    Posted Jul 18, 2018 01:48 PM

    well that is disappointing, i was trying to do the exact same thing as you were!  Thanks for posting the result so i can stop trying to do it.