Network Management

Reply
Contributor II
Posts: 90
Registered: ‎12-06-2014

Airwave discovery

I setup AMP but the discover does not pick up any devices. If I add my Aruba controller manually it picks it up but cannot read any of the configuration for it or the APs. Using snmp v1 & v2. Any suggestions? 

Guru Elite
Posts: 20,571
Registered: ‎03-29-2007

Re: Airwave discovery

Check to see if anything is under New Devices.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor II
Posts: 90
Registered: ‎12-06-2014

Re: Airwave discovery

yes I see the devices after adding the controller in manually but no config info. Want to do a discovery to pick up all the cisco switches but not working. 

Guru Elite
Posts: 20,571
Registered: ‎03-29-2007

Re: Airwave discovery

The username and password for the device(s) need to be correct for config info.  Double check the username, password and enable password under Manage.

For discovery to work, you need to enter the correct username and password and snmp string under the manufacturer.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: