Network Management

Reply
New Contributor

Connection Between Controller and AP

Hello good afternoon to the whole community, I have a small problem with my laboratory and I'm doing an installation in my network of a 620 controller and an AP 105, the controller configuration is checked and it is good to connect the AP it takes it as an air monitor and will not let me out of that state. I tried restarting the AP but in turn it keeps giving me the same error. Someone here will have an idea why I have this problem?

Moderator

Re: Connection Between Controller and AP

The radio mode is maintained by the radio profile.  So you need to drill down into config -> ap config -> ap group -> RF mgmt -> select radio profile -> set mode to ap-mode instead of am-mode.

2017_12_13-903.jpg

 

 

 


Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: