Network Management

Reply
Occasional Contributor II
Posts: 18
Registered: ‎06-02-2014

Error fetching existing configuration on Airwave

Hi All,

 

We encounter an issue via Aruba Controller "Error fetching existing configuration" on Airwave, some APs shows up while the rest of APs and Aruba Controller shows down on Airwave. We already run snmp walk from Airwave to Aruba Controller and there is a response. Also, ping is successfull from Airwave to Controller. Please see attached for reference. 

 

Thanks! 

 

Comments and Suggestions are highly appreciated.

 

Kim

Occasional Contributor II
Posts: 18
Registered: ‎06-02-2014

Re: Error fetching existing configuration on Airwave

Also, the number of APs up on the controller is 58 but it shows only 24 APs up on Airwave.

 

Please see attached for reference.

 

Thanks! 

 

 

Guru Elite
Posts: 20,773
Registered: ‎03-29-2007

Re: Error fetching existing configuration on Airwave

kim.dado,

 

When did this start happening?

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

MVP
Posts: 1,415
Registered: ‎10-25-2011

Re: Error fetching existing configuration on Airwave

What are your thresholds for SNMP retries and timeout set to? This is Device Setup -> Communication.

Have you tried another poll on the controller itself?
What is your poll time set to in the Airwave group?
Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
Search Airheads
Showing results for 
Search instead for 
Did you mean: