Network Management

last person joined: 4 hours ago 

Keep an informative eye on your network with HPE Aruba Networking network management solutions
Back to discussions
Expand all | Collapse all

Upgraded to cannot login via WebUI

This thread has been viewed 2 times

  • 1.  Upgraded to cannot login via WebUI

    Posted Aug 30, 2016 01:49 PM

    After I upgraded to 8.2.2, I was able to login after the upgrade a few days ago. I went to login today my user name and the admin user is not allowing login via WebUI. But I can login via CLI with root. Any way of getting into the WebUI?



  • 2.  RE: Upgraded to cannot login via WebUI

    Posted Aug 30, 2016 02:30 PM
    I experienced that behavior twice a couple months ago with our two airwave instances and discovered we had ran out of disk space on the both servers (different causes but same outcome). That might be the cause although could be something else. I think you can check your disk availability with "df -h".


    #AirheadsMobile


  • 3.  RE: Upgraded to cannot login via WebUI

    Posted Aug 31, 2016 09:41 AM 
    That was my first thought. I had enough space over 5 GB. I tried amp_disable and then amp_enable. I now get a message at the bottom saying, "DISABLED - 1" and the WebUI does not allow connections. I am going to open a ticket with TAC.