Network Management

Reply
Contributor I
Posts: 23
Registered: ‎11-13-2012

Wireless Controller read-only role does not have access to show commands

I am trying to create a user on our Wireless Controller(Aruba7205) that will use the mgmt-user read-only role.  I am able to create the user but when I log onto the CLI of the controller the user does not have access to show commands.  I am also not able to enter enable mode while using the read-only mgmt-user role.  Is there something else that needs to be done to use the read-only role?  I am able to log onto the CLI of the controller with the username and password I just don't have access to show commands.  Thanks!

MVP
Posts: 930
Registered: ‎04-13-2009

Re: Wireless Controller read-only role does not have access to show commands

Hi,

 

It seems to work ok for me. I'm on 6.5.1.1.

 

I'm logged in with rotest below:

rotest.jpg

 

Cheers

James

Cheers
James

-------------------------------------------------------
-------------------@whereisjrw-------------------
------------------------blog-------------------------
ACCX #540 | ACMX #353 | ACDX #216
-----------Mobility First Expert #11----------
-------------------------------------------------------

If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.
Contributor I
Posts: 23
Registered: ‎11-13-2012

Re: Wireless Controller read-only role does not have access to show commands

Thanks JR!  I realised I had to enter enable mode to use the show commands when signed in as a read-only user.  Another thing that threw me was the read-only user can also enter configure terminal mode but they are not able to make changes.  It kind of rubbed me the wrong way since I would think a read-only user would not be able to access configure mode.  Thanks for the reply!

Search Airheads
Showing results for 
Search instead for 
Did you mean: