Network Management

Reply
New Contributor
Posts: 3
Registered: ‎09-14-2016

how to display all APs on my controller

Hello,

 

How can I display all my APs seen by my controller at once.  The command is >show ap database ( database-summary).  But this gives me just few at the time. i need them all so I can copy and paste it to a spreadsheet. 

 

Thanks

 

Ray

Guru Elite
Posts: 8,732
Registered: ‎09-08-2010

Re: how to display all APs on my controller

show ap database long | redirect-output



This will dump out a text file in the controller flash.

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Guru Elite
Posts: 21,480
Registered: ‎03-29-2007

Re: how to display all APs on my controller

[ Edited ]

DariusTheGreat wrote:

Hello,

 

How can I display all my APs seen by my controller at once.  The command is >show ap database ( database-summary).  But this gives me just few at the time. i need them all so I can copy and paste it to a spreadsheet. 

 

Thanks

 

Ray


On the commandline, if you type "config t no paging" and then enter, it will give you output with no page breaks..

 

EDIT:  Just "no paging" in enable mode should work.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 3
Registered: ‎09-14-2016

Re: how to display all APs on my controller

Thanks so much.  It worked like a charm.

New Contributor
Posts: 3
Registered: ‎09-14-2016

Re: how to display all APs on my controller

Thanks so much.  This work well

Search Airheads
Showing results for 
Search instead for 
Did you mean: