Security

Reply
Contributor II
Posts: 100
Registered: ‎10-04-2012

Clearpass CLI

Hello Airheads,

what does "lookup static" mean in Clearpass CLI when you run the "network ip list" command?

 

Guru Elite
Posts: 7,852
Registered: ‎09-08-2010

Re: Clearpass CLI

I believe those are manual IP table entries.


Tim Cappalli | Aruba ClearPass TME
@timcappalli | ACMX #367 / ACCX #480 / ACEAP / CWSP
Contributor II
Posts: 100
Registered: ‎10-04-2012

Re: Clearpass CLI

thanks Tim,

Appreciate your reply

i didn't phrase the question very well.

On the CLI I have entered a static route which Clearpass accepted.

If i then type in "network ip list" the next hop is shown up as "lookup static"

I have no means of looking up static!!

I have pulled the logs off the controller bu it says the same thing.

cheers

Pete

 

Regular Contributor II
Posts: 226
Registered: ‎03-03-2011

Re: Clearpass CLI

I'm pretty sure this is just the way Clearpass shows static routes. Can you post the output so we can see?

David
ACDX #98 | ACMP | ACCP
Search Airheads
Showing results for 
Search instead for 
Did you mean: