I must be missing something in my configuration.
I am trying to setup LACP between my backup controller and my Aruba switch stack. This will run over ethernet via the 1st and 2nd port (0/0/0 and 0/0/1) to ports on my switch stack (2/0/43 and 6/0/47)
Whenever I setup the Port Channel/LACP on the controller I lose access to the controller. (Even when I add the ethernet ports on the switch to an LACP profile)
The configuration on the controller looks like this:
interface port-channel 1
trusted
trusted vlan 1-4094
switchport mode trunk
no spanning-tree
interface gigabitethernet 0/0/0
description "LACP to Switch Stack"
trusted
trusted vlan 1-4094
lacp group 1 mode active
interface gigabitethernet 0/0/1
description "LACP to Switch Stack"
trusted
trusted vlan 1-4094
lacp group 1 mode active
On the Aruba Switch stack it looks like this:
interface-profile lacp-profile "LACP_ToBackupController"
group-id 3
mode active
interface gigabitethernet "2/0/43"
description "LACP to BackupController"
lldp-profile "lldp-factory-initial"
lacp-profile "LACP_ToBackupController"
interface gigabitethernet "6/0/47"
description "LACP to BackupController"
lldp-profile "lldp-factory-initial"
lacp-profile "LACP_ToBackupController"
What am I overlooking?