Wired Intelligent Edge (Campus Switching and Routing)

Reply
Occasional Contributor II

i am doing a lab on directin guest on gre tunel using dmz and master (itself local)controller

The guest user showing drop in process logs ...but its showing connected and it taking virtual vlan ip address 192.168.150.2 which is assigned to vlan 150 for tunneling...and also its not showing captive portal when connected..what might be the issue can you please suggest me.......and i follwed this link  https://community.arubanetworks.com/t5/Controller-Based-WLANs/How-do-I-redirect-guest-access-across-a-GRE-tunnel-to-a-DMZ/ta-p/183468

if u have gui screen shots for the same access control policy ..share me

Regards,

Mallikarjun

Guru Elite

Re: i am doing a lab on directin guest on gre tunel using dmz and master (itself local)controller

You need to make the DMZ Size of the tunnel to be "untrusted" for the captive portal to come up..

 

The message you are observing looks like it is ARP spoofing, where a device has the same mac address as another device in the user table..


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Occasional Contributor II

Re: i am doing a lab on directin guest on gre tunel using dmz and master (itself local)controller

Hi Collin,

i have done with untrusted tunnel cmd  also..its not working ..

Regards,

Mallikarjun

 

 

Occasional Contributor II

Re: i am doing a lab on directin guest on gre tunel using dmz and master (itself local)controller

Is all below policies are mandatory.. i tried with the below  cmds

its not working

Configure common alias to be used in policy creation on master controller:

Configure guest ‘pre-logon’ basic services policy on master controller: 

Configure guest ‘pre-logon’ captive portal policy on master controller: 

Configure the guest ‘pre-logon’ role using the above two policies on master controller:  

Change default ‘cplogout’ policy on master controller:

Configure guest ‘allowable use’ policy on master controller:

Configure guest ‘post-logon’ role on master controller:

Configure SSID derivation of guest role based on guest SSID on master controller:    

Configure Aruba captive portal on master controller:  

 

Regards,

Mallikarjun

Guru Elite

Re: i am doing a lab on directin guest on gre tunel using dmz and master (itself local)controller

Let's start with what is working and take it from there.  Can you pass traffic through the tunnel?  To find this out, you should type "show datapath tunnel table" on both controllers and see if the encrypts and decrypts number is going up for the GRE tunnel.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: