Wireless Access

Reply
Frequent Contributor II
Posts: 106
Registered: ‎10-20-2011

AP 215 / 7210 controller and VOIP

Hello,

 

I'm trying to enhance our VOIP over our WiFi.  I've set the following Rules for the ports our Mitel system uses.  Is there anything else I can do to enhance the traffic?  All traffic is being tunneled back through to the controller then to the phone system.  Thanks for any thoughts.

 

Screen Shot 2016-04-13 at 8.49.19 AM.png

Guru Elite
Posts: 21,279
Registered: ‎03-29-2007

Re: AP 215 / 7210 controller and VOIP

Are you certain that your Mitel Phones do not support SIP?



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor II
Posts: 106
Registered: ‎10-20-2011

Re: AP 215 / 7210 controller and VOIP

Thanks for the repsonse.  I actually made a few network tweaks.  I noticed that the device was not connecting to the 5 GHZ network I intended it to connect to.  I made some modifications to my ARM config and lowered the 2.4 GHZ transmit powers and turned on band steering.  I also noticed that the client was using rtp to communicate back to the VOIP system.  I assigned priority to RTP for the profile the clients would have.  I also assigned port priority on my Enterasys switch where the VOIP system is plugged in.  All have seemed to help keep connection better.

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: