Wireless Access

Reply
Occasional Contributor II

AP 225 shows Power LED as amber after upgrade to 6.5.3.3

Hello Experts .

 

i performed a software upgrade on a 7030 pair in master-standy from OS 6.4.2.9 to 6.5.3.3.

 

after the customer says that he has noticed the POWER LED of the 225 ap's ( all the ap's are ap 225 ) shows up as "amber".  prior to the upgrade they were showing up as "green".

 

i saw on airheads what does it mean for the Power led to go amber which is "

Power LED goes amber instead of green when the switch port to which the AP is connected is POE (802.2af) instead of POE+ (802.2at)."

 

morover the flags that i see for all the ap's controller is "A2da" , so is there anything un-usual which has occured , i am not sure ?

Guru Elite

Re: AP 225 shows Power LED as amber after upgrade to 6.5.3.3

Typically Amber means you are not using AT power.  How are your APs being powered?

 

******************
Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.
******************
Occasional Contributor II

Re: AP 225 shows Power LED as amber after upgrade to 6.5.3.3

hi there, thanks for confirming this to me.  i was concerned if this could be an issue.

i already have asked the customer to check this.

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: