Hi Folks,
I'm new to the Aruba system and have a slight problem that I'm not sure what I doing wrong and was hoping for some advice.
I initially had 34 APs licensed and connected to a W-7210 - all working fine. Phase 1 of a larger roll-out.
I have purchased two additional APs and all the correct licenses. These licenses have been activated and added to the controller. I can see under network > controller > license management that the number of APs has increased from 34 to 36. As has the "RF Protect" and "Next Generation Policy Enforcement...." both show 36 now.
However when I go to the configuration > AP installation > provisioning page I cannot see the new APs.
I hasten to add that the APs are correctly plugged into the network and I can trace the devices' MAC address across the network.
Is there something else that needs to be done to the controller etc that would enable it to find and configure these two new APs?
I should point out that I haven't yet rebooted the controller, perhaps I should?
Hope someone can advise.
Many thanks
Mark