Dear All,
1. Having All Masters architecture, Adding to AMP only active Master will also automatically add Standby and populate its configuration to AMP? Or each should be addes manually.
2. With OEM controllers like ALU or Dell is it possible to add a device to AMP using: Device Setup -> Add -> Aruba device, instead of using 'Alcatel-Lucent OAW' or 'Dell Controller'?
The only difference between 'Aruba Device' and those two others is SNMPv3 Auth Protocol setting (SHA-1 for Aruba and MD5 for ALU and Dell), which I believe is wrong. At least AMP docs underline SNMPv3 Auth Protocol should always be SHA-1.
3. I want to have full stats on AMP with event corelation, so I would like to have a WMS Offload 'copy' on AMP without actual full WMS Offloading from master controllers (it is small network, no big load on controllers).
To achieve this, is it enought to config:
AMP Setup -> General -> Device Configuration (tab) 'Allow WMS Offload configuration in monitor-only mode' = YES, and
Group -> Basic -> Aruba (tab) Offload WMS Database = NO ?
AirWave Best Practices Guide is a bit confusing on this.