HI,
i'm trying to work with Aruba AP 105 model.
i've connected it to the Aruba controller, using these commands:
pboot> purgeenv
Un-Protected 1 sectors
.done
Erased 1 sectors
Writing
apboot> set master <controller-ip>
apboot> set serverip <controller-ip>
apboot> set bootcmd tftpboot
apboot> save
Saving Environment to Flash...
Un-Protected 1 sectors
apboot> boot
but after that the AP can't come up - it's in a loop of reboots and the console output is:
eth0 up: 1 Gb/s full duplex
DHCP broadcast 1
DHCP IP address: 192.165.100.254
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 192.165.100.10
DHCP DNS server: 0.0.0.0
DHCP DNS domain:
Controller address: 192.165.100.3
Using eth0 device
TFTP from server 192.165.100.3; our IP address is 192.165.100.254
Filename 'mips32.ari'.
Load address: 0x2000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
eth0 up: 1 Gb/s full duplex
DHCP broadcast 1
DHCP IP address: 192.165.100.254
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 192.165.100.10
DHCP DNS server: 0.0.0.0
DHCP DNS domain:
Controller address: 192.165.100.3
Using eth0 device
TFTP from server 192.165.100.3; our IP address is 192.165.100.254
Filename 'mips32.ari'.
Load address: 0x2000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
eth0 up: 1 Gb/s full duplex
DHCP broadcast 1
DHCP IP address: 192.165.100.254
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 192.165.100.10
DHCP DNS server: 0.0.0.0
DHCP DNS domain:
Controller address: 192.165.100.3
Using eth0 device
TFTP from server 192.165.100.3; our IP address is 192.165.100.254
Filename 'mips32.ari'.
Load address: 0x2000000
Loading: T T T T T
any idea what went wrong?
just a note: i've managed once to add it to the controller using the above commands.
(the controller showed the AP in the AP list)
but when i changed the AP name (in the controller under Configuration -> AP Installation) the AP got stuck in the reboot loop..
when i retried to attach the AP to the controller i got again the reboot loop..
thanks for any help :)