I am programming a large amount of Aruba IAP 325 access points for a customer that we normally provide controller based solutions for and I am having some issues mimicing our controller config onto an IAP. I know it is impossible to get all of the features, but I would figure VRRP settings would be pretty standard unfortunately I am unable to find any VRRP settings or settings to mimic what I do with VRRP on our aruba controllers.
We run the following commands on our Aruba controller:
vrrp 129
priority 110
authentication [Password]
ip address xx.xx.xx.xx
vlan 129
preempt delay 0
tracking master-up-time 30 add 20
no shutdown
!
vrrp 118
authentication [Password]
priority 110
ip address xx.xx.xx.xx
vlan 118
preempt delay 0
tracking master-up-time 30 add 20
no shutdown
I am sure it is somewhere obvious, but Is there a way to mimic these specific commands function within the aruba IAP?. Authentication is absolutely needed.