Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

CLI command for POE to power up the IAP-135?

This thread has been viewed 0 times

  • 1.  CLI command for POE to power up the IAP-135?

    Posted Jun 10, 2014 03:30 AM

    Currently, I am doing a setup with a Aruba A620 controller and a IAP-135.

     

    The PoE port of the controller is connected to the ENET0 port of IAP-135.

    However, the controller did not power up the IAP-135.

    What is the CLI command to power up?

     

    Please advise.

     



  • 2.  RE: CLI command for POE to power up the IAP-135?
    Best Answer

    Posted Jun 10, 2014 04:22 AM

    1.only the 4 ports at the bottom got poe support.

     

    http://community.arubanetworks.com/t5/Unified-Wired-Wireless-Access/620-maximum-PoE-ports/td-p/30718

     

    2.When (and if) you "factory defaulted", did you use "write erase all" or just "write erase"?  The "write erase all" command erases the licenses.  There is a license on all 6xx series controllers that enables PoE.  If you deleted this, you will need to call support and get it re-enabled (or import the previous licenses that you backed up before you erased them).

     



  • 3.  RE: CLI command for POE to power up the IAP-135?

    Posted Jun 10, 2014 05:35 AM

    Thanks kdisc98,

     

    I unintentionally write erase all (removed all licences).

     

    I have already resolved this issue. Thanks



  • 4.  RE: CLI command for POE to power up the IAP-135?

    Posted Jun 10, 2014 04:38 AM

    show license to see if you have Poe license loaded?

     



  • 5.  RE: CLI command for POE to power up the IAP-135?

    Posted Jun 10, 2014 04:39 AM
    yep,after enable
    just show lic