Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Cisco WLC 7.4

This thread has been viewed 1 times

  • 1.  Cisco WLC 7.4

    Posted Feb 05, 2013 06:49 AM

    Hi,

     

    Is it possible to manage/monitor Cisco controllers running 7.4 code ?

     

     

    Thanks



  • 2.  RE: Cisco WLC 7.4
    Best Answer

    EMPLOYEE
    Posted Feb 05, 2013 04:46 PM

    No specific support has been added for Cisco controllers on firmware 7.4.x.x.  The last tested version was 7.3.101.0 in AMP 7.6.

     

    If you're running AMP 7.6 and are seeing anything not working properly, it's worth it to open a support case.

     

    If you're asking as a prior measure before upgrading your controller firmware, typically monitoring will be available.  Management of new features may not be included (these would be worth filing as feature requests in the Ideas Portal on the support site for future improvement).



  • 3.  RE: Cisco WLC 7.4

    Posted Feb 05, 2013 05:58 PM

    Ok, thanks Rob



  • 4.  RE: Cisco WLC 7.4

    Posted Jan 24, 2014 11:00 AM
    @rgin wrote:

    No specific support has been added for Cisco controllers on firmware 7.4.x.x.  The last tested version was 7.3.101.0 in AMP 7.6.

     

    If you're running AMP 7.6 and are seeing anything not working properly, it's worth it to open a support case.

     

    If you're asking as a prior measure before upgrading your controller firmware, typically monitoring will be available.  Management of new features may not be included (these would be worth filing as feature requests in the Ideas Portal on the support site for future improvement).

    Can documentation get updated because as of 7.7.8 it says the following:

    Capture.PNG