Wireless Access

last person joined: 13 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Configure AP for dhcp using console cable

This thread has been viewed 0 times

  • 1.  Configure AP for dhcp using console cable

    EMPLOYEE
    Posted Sep 14, 2012 10:20 PM

    Hi,

     

    What is the setenv command to set an ap to get an address via dhcp?

     

    I have some RAPs used for surveying (with static ip) and need to reprovision them to different ap-group from a hotel.  They are currently setup with static ip, so need them to boot up and get dhcp, and then hopefully they can reach the controller.

     

    Thanks



  • 2.  RE: Configure AP for dhcp using console cable

    EMPLOYEE
    Posted Sep 14, 2012 10:25 PM

    Think I found it. Either,

     

    setenv dhcp

    or

    dhcp

     

    :smileyhappy:



  • 3.  RE: Configure AP for dhcp using console cable

    Posted Sep 15, 2012 11:26 AM

    you do need the set command before dhcp. It can be 

     

    set dhcp

    or

    setenv dhcp