Wireless Access

Reply
Frequent Contributor II
Posts: 479
Registered: ‎03-15-2014

I have or pre-sales ordered 300 IAP and controller and on site now we want to convert all?

Want to know how to convert 300 IAP to controller atonce how can I do this?

Guru Elite
Posts: 21,515
Registered: ‎03-29-2007

Re: I have or pre-sales ordered 300 IAP and controller and on site now we want to convert all?

You can convert an entire cluster at one time.  You would have to bring as many of the IAPs up as possible in a single cluster and then go to Maintenence> Convert to convert them.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor II
Posts: 479
Registered: ‎03-15-2014

Re: I have or pre-sales ordered 300 IAP and controller and on site now we want to convert all?

Great so this will convert them all great

Aruba
Posts: 1,644
Registered: ‎04-13-2009

Re: I have or pre-sales ordered 300 IAP and controller and on site now we want to convert all?

If the IAPs are not deployed, an alternative would be to configure Aruba Activate to convert them to Campus-based APs.     As each one comes online, it will communicate with Activate, retrieve its provisioning rule, and convert.   Be sure the controller is configured and online prior to brining the IAPs up.

 

Have a look at this tutorial that converts IAPs to Campus-based RAPs; you would just change the provisioning rule form IAP-to-RAP to IAP-to-CAP.

http://community.arubanetworks.com/t5/Unified-Wired-Wireless-Access/Tutorial-Provisioning-RAPs-with-Aruba-Activate-Dec13-Tutorial/m-p/128707/highlight/true#M27559

 

 

http://www.arubanetworks.com/pdf/products/FS_Activate.pdf

https://activate.arubanetworks.com/registration/ 

 

------------------------------------------------
Systems Engineer, Northeast USA
ACCX | ACDX | ACMX

Search Airheads
Showing results for 
Search instead for 
Did you mean: