Hello everyone,
I have a 620 controller running 6.3 and I have two IAP-105. I have them connected to the controller to get PoE and DHCP from a pool I created inside the 620. Both IAP are factory reset.
I can’t have them to boot up and find the controller for some reason. The DHCP pool is for vlan 55 the controlled ip address is 172.19.88.1 which is the default gateway for my DHCP pool, ports 0-1 are on that vlan and going to the APs. I did cli purngeenv but still nothing. I have disabled the control plane security on the controller.
Any ideas on what is missing here?
Thanks,