Wireless Access

last person joined: 8 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Is it possible to NAT certain traffic and route other traffic within the same VIA profile?

This thread has been viewed 0 times

  • 1.  Is it possible to NAT certain traffic and route other traffic within the same VIA profile?

    Posted Feb 15, 2014 05:05 PM

    I'm trying to allow softphone usage for VIA clients. When the softphone connects to the controller, it shows up on the phone switch with the IP address of the controller.  What I'd like to do is route traffic that matches the destination IP of our phone switch and NAT the rest.

     

    Unless there is a better way, of course.

     

    Thanks,

    Robert 



  • 2.  RE: Is it possible to NAT certain traffic and route other traffic within the same VIA profile?

    EMPLOYEE
    Posted Feb 15, 2014 05:16 PM
    RobertBW,

     You can:

     

    1.  Consider a subnet that would be fully routable in your network

    2.  Create a pool of addresses on the controller for VIA that matches addresses on this subnet, and replace the pool for clients that you are using with it.

    3.  Create a route in your network for that subnet that points to the controller's management ip address

    4.  Remove any source-nat statements in the Via user role.