Recently, after a support call with Aruba, some of my AP135 and AP124s will connect to the controller, show UP for only 1 minute and then show down. This cycle repeats over and over again.
Connected via a console cable:
- AP gets and IP and does see the master controller for which it is supposed to talk to.
- However, if I let it finish the boot process, the AP just sits there with power flashing and enet0 flashing away.
- To get the AP to boot properly, I have to interrupt the boot process and at the command line, type boot then enter.
The AP will boot up and I can connect to it. I tried a seperate VLAN, checked DHCP options, and everything else I could. There are other 135 APs plugged into the switch that are working fine. I cannot figure it out, nor do I really want to go to each AP, plug in my console cable and type boot. When I do this, I try to reboot the AP normally, but then go back to power flashing and enet0 or 1 flashing and never finishes the boot process.
#AP135