Wireless Access

Reply
Regular Contributor II
Posts: 202
Registered: ‎01-30-2013

MST 200 Configuration

Hi all

 

we are configuring two MST200 and we need that 2 vlans pass throught the antenas.

 

This antennas are connected to a Nortel 3524 Switch.

 

We have done the configs with the port on the switch to be trunk mode ( allowed both vlans) and also tried to trunk the port on Aruba to be alowwed both vlans.

 

Is this sufficient to be able to have traffic on both vlans ?

 

We are only having traffic on data vlan 1 , vlan 4 that is voip , is not getting to the other side.

 

Since i am new to this MST´s , am I missing some config?

 

Does Vlan 4 needs to have an Ip address?

 

 

 

Regards

MVP
Posts: 340
Registered: ‎04-25-2013

Re: MST 200 Configuration

Hi,

your config seem to be correct,

you do not need to configure an address IP in each VLAN unless you need that your AP become reacheble from both VLAN (without intervlan routing)

Regards

Raouf CHAHBOUNE
ICT Network & Security Engineer
CCNP R/S | CCNA Security | ACMP|ACDX



[If my post is helpful please give kudos, or mark as solved if it answers your post.]
Regular Contributor II
Posts: 202
Registered: ‎01-30-2013

Re: MST 200 Configuration

Hi,

 

It seems it was a untagged pvid only setting. For now everything is working ok

 

Regards

MVP
Posts: 340
Registered: ‎04-25-2013

Re: MST 200 Configuration

good news :)
Raouf CHAHBOUNE
ICT Network & Security Engineer
CCNP R/S | CCNA Security | ACMP|ACDX



[If my post is helpful please give kudos, or mark as solved if it answers your post.]
Search Airheads
Showing results for 
Search instead for 
Did you mean: