Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Make AP flash to identify it's location

This thread has been viewed 3 times

  • 1.  Make AP flash to identify it's location

    Posted Nov 14, 2014 08:35 AM

    Is anyone aware of any options where you can make an AP flash it's LEDs to identify itself from other APs?  We has some new APs installed and it is difficult to determine which is which on the ceiling.



  • 2.  RE: Make AP flash to identify it's location
    Best Answer

    Posted Nov 14, 2014 08:39 AM

    the command to use is ap-leds.

     

    (aruba-7010) #ap-leds ?
    all                     Control LEDs on all APs
    ap-group                Control LEDs on APs in this group
    ap-name                 Control LEDs on AP with this name
    ip-addr                 Control LEDs on AP at this IP address
    wired-mac               Control LEDs on AP at this MAC address

     

    ap-leds ap-name <NameofAP> blink

    ap-leds ap-name <NameofAP> normal

     



  • 3.  RE: Make AP flash to identify it's location

    Posted Nov 14, 2014 08:40 AM

    Thanks!!!!  :D