Wireless Access

Reply
Contributor I
Posts: 79
Registered: ‎04-09-2014

Master-Local: Do I need to have the same firmware version on both (Master and Local) WLCs?

I'm trying to set up a Master-Local configuration, but I'm wondering if I need the same firmware version on both?.

Also I'm kinda confused with the VLANs setup on each, to allow the SSIDs to work properly?

 

Thanks,


EH

Guru Elite
Posts: 8,337
Registered: ‎09-08-2010

Re: Master-Local: Do I need to have the same firmware version on both (Master and Local) WLCs?

Yes, they need to match.

 

You can either have the same VLANs on both for failover or different VLANs and then utilize named VLANs to assign to the virtual-ap profile.


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Contributor I
Posts: 79
Registered: ‎04-09-2014

Re: Master-Local: Do I need to have the same firmware version on both (Master and Local) WLCs?

Hi,

 

Thanks for you answer. Is there a guide to review designs for this Model. I want to check if I'm going to configure this properly.

 

Thanks,

Guru Elite
Posts: 8,337
Registered: ‎09-08-2010

Re: Master-Local: Do I need to have the same firmware version on both (Master and Local) WLCs?

Yes, there is a mobility controller VRD. Just keep in mind that some newer functionality like HA are not covered in the document. You should use the AOS 6.3 / 6.4 user guide to configure HA.

 

http://community.arubanetworks.com/t5/Validated-Reference-Design/Aruba-Mobility-Controllers/ta-p/155472

 

http://community.arubanetworks.com/t5/Validated-Reference-Design/Campus-Network-Design-V-8/ta-p/155134

 

 

 

 


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Search Airheads
Showing results for 
Search instead for 
Did you mean: