Wireless Access

Reply
Contributor I

Problem in RF Management AP Mode

Hi Everyone,

 

The issue is in RF Management, the Access Point is already in AP mode. However, looking at monitoring, it shows that the AP is still in monitor mode. The model of AP is Apin0325 while for the controller it is 7210. The firmware version of the controller is 6.5.0.4.

 

Hoping that you guys can help. It will be greatly appreciated.

Guru Elite

Re: Problem in RF Management AP Mode

On the commandline, "show ap active" should tell you the mode of the radio accurately.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I

Re: Problem in RF Management AP Mode

Thanks Colin.

Contributor I

Re: Problem in RF Management AP Mode

Hi Guys,

 

Additional information. 11a and 11g are in AM. What is the command to set 11g ch/eirp/maxeirp to AP?

Re: Problem in RF Management AP Mode

First, what country code is this controller set to (or what country are you in)? You may need to download a new DRT file from support to get the latest regulatory information for your AP (assuming it's not configuration related). If you put the 325 into the same group as any of your other APs that are running fine, and if the radios don't come up, 99/100 it's regulatory and you likely need to upgrade code or just upgrade the DRT file to allow the 325 to run.

Jerrod Howard
Sr. Techical Marketing Engineer
Contributor I

Re: Problem in RF Management AP Mode

Hi Sir Jerrod,

 

Is there a way to configure the country code of Aruba ap-325? The unit seems no GUI so maybe theres a way in configuring the country code in CLI. Thanks.

Re: Problem in RF Management AP Mode

What country code and controller type (US, RW, IL, JP, etc) is it?

Jerrod Howard
Sr. Techical Marketing Engineer
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: