Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Problems when provisioning CAPs

This thread has been viewed 0 times

  • 1.  Problems when provisioning CAPs

    Posted Apr 21, 2017 06:04 PM

    Hi guys,

    After upgrading my controller to 6.5.1.0 I was able to convert two IAPs to CAPs and be managed by the controller. However, I have provisioned successfully my AP 325 to my AP group, it is working properly, but I have problems provisioning my AP 305 to the same group, I don't know the reason. CPSec is disabled. Attached the following screenshots.
    Both APs seem to be up
    1.PNG

    After clicking on number 2 in the Access Points row I get this
    2.PNG

    If a click on the MAC address of the 305 AP I get this
    3.PNG

    After a few seconds the AP is down in Monitoring>Network Summary
    4.PNG

    If a click on the red number 1 in the Access Points row I get this
    5.PNG

    AP 305 is alternating between up and down. The System Status LED is always in green intermittent state.
    I don't know how to troubleshoot this issue or the command to use. Please help.

    Regards,
    Julián



  • 2.  RE: Problems when provisioning CAPs

    EMPLOYEE
    Posted May 18, 2017 02:55 PM
    Type "show log system 50" on the command line and see if it gives you any clues about that access point.