Cellular Hand-off assist feature works on the top of our ARM client-match feature. This needs to be enabeld only based on specific deployments when cllients connected to edge AP`s.
Yes; enabling on VAP profile will help to turn on/off the feature. Client match Sticky Min signal is the value to kick in the CHA feature; we could increase or decrease the value based on the requirement however i would recommend to discuss this with TAC before we enable or doing any config changes on the controller.
Client Match Sticky Min Signal 65
Client Match Steering Timeout (sec) 10
(sri-7240-xm) #show wlan virtual-ap default
Virtual AP profile "default"
----------------------------
Parameter Value
--------- -----
AAA Profile default
802.11K Profile default
Hotspot 2.0 Profile N/A
SSID Profile default
Virtual AP enable Enabled
VLAN N/A
Forward mode tunnel
Allowed band all
Band Steering Disabled
Cellular handoff assist Disabled
Thank you,
Sriram