wrote:
Not sure if I need to get the modeswitch message somewhere and add that to the parameters as well? If so, how can I get the message? Google doesn't seem to find it.
That is the modeswitch message, taken from the modeswitch website (google: usb_modeswitch Telewell 0x2020 0x2033) and then look at the discussion, seems a normal eject will work.
Can you post the entire config for the modem, not just the pre and post switch IDs?
A couple of options can be tried now. First, setup your RAP to do dual uplink, 4G first then wired second. Let it fail on the 4G modem then connect via wired, then you can get the logs out of it (show ap debug <>) and try to see any error that points you in the right direction.
show ap sapd-debug log ap-name <>
show ap debug log ap-name <>
show ap debug usb ap-name <>
Alternatively, you may be to boot up a small linux install from USB on a laptop, install usb_modeswitch if it doesnt already have it, then try to find the correct combination of modeswitch params that work from the CLI to get it to work.
Once you have that, it can be copied into the Aruba modeswitch value as was just tried.
Oh, just in case, there is no need to include the word "usb_modeswitch" in variable, this field is used to pass params to modeswitch, it's not a freeform box to run any old file from the AP file system.