Wireless Access

last person joined: 19 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Radio Profile and ARM

This thread has been viewed 7 times

  • 1.  Radio Profile and ARM

    Posted Aug 06, 2018 05:35 PM

    Hi.

     

    My APs are model 135 and controller is 3400. 

    In Configuration > AP Group > RF MANAGEMENT

     

    Is it correct?  My 802.11A RADIO Profile set channel width 20 Mhz, and ARM Allowed bands for 40MHz channels set to "all" and is set ==>80MHz support?

     

    Another question: If it is correct, I can set 802.11A RADIO Profile width to 40 or 80 Mhz?

     

    Thks for your attention.

     

    Paulo Maurício



  • 2.  RE: Radio Profile and ARM
    Best Answer

    EMPLOYEE
    Posted Aug 06, 2018 07:30 PM

    The radio profile is only in effect when the ARM profile is set to "disabled".  ARM by default is single-radio, and the ARM profiles is used to configure access points.



  • 3.  RE: Radio Profile and ARM

    Posted Aug 07, 2018 12:21 PM

    Thks for your help.

     

    Some questions if you can help me.

     

    What is your recommendation for regulatory domain and ARM, for best clients healthy and channel quality.

     

    We have poor clients healthy, our intention are getting better channel quality and client healthy, and decrease noise.

     

    Is there a way to force a client to migrate to a near AP? I have cases the client don't change, even if the poor signal.

     

    Thks .