Green power LED bulb blinking continuously.
Item reset several times , but system not initialized, problem still there
Here is my configuration i was putting on it
setenv ipaddr 192.168.3.9
setenv subnetmask 255.255.252.0
setenv gatewayip 192.168.3.254
save
reset
And its doing this
Hit <Enter> to stop autoboot: 0
@Checking image @ 0xf6100000
Invalid image format version: 0xffffffff
@Checking image @ 0xf6800000
Invalid image format version: 0xc
eth0: down
eth1: up, 1 Gb/s, full duplex
ADP multicast 1
ADP broadcast 1
ADP multicast 2
ADP broadcast 2
ADP multicast 3
What im doing wrong?
Im still in the same thing...
@NightShade1 wrote:
I was wondering if its possible to totally config a AP for example a 105 AP im not talking about the rap 2wg....
Okay if i provision it on site and then come with my AP to the remote site okay it works fine...
But what happens if i don twant to locally provision it... let say i want to configure a AP 105 totally from factory default to connect as a remote ap to the controller?
this is the config i was putting on it
setenv ipaddr 192.168.3.171
setenv subnetmask 255.255.255.0
setenv gatewayip 192.168.3.254
setenv serverip 200.75.219.13
setenv master 200.75.219.13
save
reset
And its doing this
@Checking image @ 0xbf100000
Invalid image format version: 0xffffffff
@Checking image @ 0xbf800000
Invalid image format version: 0xffffffff
eth0 up: 100 Mb/s full duplex
DHCP broadcast 1
*** Unhandled DHCP Option in OFFER/ACK: 28
*** Unhandled DHCP Option in OFFER/ACK: 28
DHCP IP address: 192.168.3.122
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 192.168.3.254
DHCP DNS server: 192.168.3.254
DHCP DNS domain:
Using eth0 device
TFTP from server 200.75.219.13; our IP address is 192.168.3.122; sending through gateway 192.168.3.254
Filename 'mips32.ari'.
Load address: 0x2000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
eth0 up: 100 Mb/s full duplex
DHCP broadcast 1
*** Unhandled DHCP Option in OFFER/ACK: 28
*** Unhandled DHCP Option in OFFER/ACK: 28
DHCP IP address: 192.168.3.122
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 192.168.3.254
DHCP DNS server: 192.168.3.254
DHCP DNS domain:
Using eth0 device
If you see its putting another IP not the one i put it through the cli console... and its stuck doing that...
What im doing wrong?
i also tried doing
setenv remote_ap=1
Im still in the same thing...
Any help?
kindly help us to solve this issue