Wireless Access

Reply
New Contributor
Posts: 1
Registered: ‎03-14-2011

Trouble with ENET1 on AP-125

Here's the scenario. I have a few pieces and parts for testing and learning set up in my house. My current set up is as follows.

 

Controller - 620-US

AP'S

AP-105 powered by PoE from the controller and set as a mesh portal.

AP-125 Powered by PD-9001G-AZ PoE+ injector set as a mesh point.

 

Problem:

 

I can't seem to get ENET1 to function so I could say use it to connect my Ethernet capable blu-ray or a network printer in the other room. I've attached screen shot of my wired AP profile.

 

I have both AP's in the same group and under the same profile, is that my problem or am I missing something else that is obvious to the more experienced Aruba masters in this community?

 

Any assistance is greatly appreciated.

 

Thanks,
Jgilb

Aruba Employee
Posts: 11
Registered: ‎04-10-2013

Re: Trouble with ENET1 on AP-125

Hello,

 

Your port is untrusted, please try to trust the port unless you have a proper AAA profile setup for this.

 

Otherwise, please provide more information.

 

Thanks!

 

GG

ACE Engineer
ACMX, ACDX, CISSP, B. Eng.
MVP
Posts: 4,301
Registered: ‎07-20-2011

Re: Trouble with ENET1 on AP-125

[ Edited ]

 

editing my response since it was already answered

Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Search Airheads
Showing results for 
Search instead for 
Did you mean: