Hi,
Can someone explain why on some controllers when I issue the command "show user-table internal", I see a long list of devices, which are the campus AP's that are connected to that controller.
Yet, on other controllers, the same command shows nothing, yet the controller code is the same, and as far as I can see, the config is the same.
Here is an example
(usbinwc1) #show user-table internal
Users
-----
IP MAC Name Role Age(d:h:m) Auth VPN link AP name Roaming Essid/Bssid/Phy Profile Forward mode Type Host Name
---------- ------------ ------ ---- ---------- ---- -------- ------- ------- --------------- ------- ------------ ---- ---------
172.16.188.227 00:00:00:00:00:00 sys-ap-role 27:23:00 TRANSPORT-VPN N/A default-cap tunnel
172.16.184.208 00:00:00:00:00:00 sys-ap-role 27:23:00 TRANSPORT-VPN N/A default-cap tunnel
172.16.184.234 00:00:00:00:00:00 sys-ap-role 27:23:00 TRANSPORT-VPN N/A default-cap tunnel
172.16.187.124 00:00:00:00:00:00 sys-ap-role 27:23:00 TRANSPORT-VPN N/A default-cap tunnel
User Entries: 251/251
Curr/**bleep** Alloc:780/319904 Free:450/319124 Dyn:1230 AllocErr:0 FreeErr:0
(uktcnwc1) #show user-table internal
Users
-----
IP MAC Name Role Age(d:h:m) Auth VPN link AP name Roaming Essid/Bssid/Phy Profile Forward mode Type Host Name
---------- ------------ ------ ---- ---------- ---- -------- ------- ------- --------------- ------- ------------ ---- ---------
User Entries: 0/0
Curr/**bleep** Alloc:231/104288 Free:137/104057 Dyn:368 AllocErr:0 FreeErr:0