Wireless Access

Reply
Contributor I
Posts: 34
Registered: ‎07-07-2011

VIA client monitoring

Hello,

 

on monitoring a VIA client, a customer of ours noticed that two entries are being shown in the Monitoring -> Clients section:

 

VIA-BGETEM-clean.JPG

 

While one entry shows the correct (and expected) "VIA-role_Test". the second one always stays in the "logon" role. The second entry also shows the official external IP address of the device, while the other one correctly shows the VPN L2TP Pool address.

Connectivity is all well, still this second entry with the "logon" role is somewhat bewildering. Can someone confirm this to be normal or is there a way to remove this entry?

 

Thanks and best regards

Guru Elite
Posts: 21,279
Registered: ‎03-29-2007

Re: VIA client monitoring

Normal.  One is for the "outer" tunnel that connects to the controller, and the other is for the client that gets its "inner"  ip address from your pool



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: