Hi guys,
I am new in controllers and a little confused about the VLAN configuration between an AP, a controller and across all the network. Here I draw two cases:
If I want to service clients in both WLANs Employee and Guest. How do every port need to be configured? Let's take VLAN 1 as the native VLAN. For example, I think is
Case A:
Eth0: Access in VLAN1
Eth1: Access in VLAN1
Gig0/0: Access in VLAN1
Gig0/1: Trunk with allowed VLANs2-3
Case B:
Eth0: Access in VLAN1
Eth1: Access in VLAN1
Gig0/0: Access in VLAN1
Gig0/1: Trunk with allowed VLANs1-3
Is this correct?
Regards,
Julián