Wireless Access

Reply
New Contributor
Posts: 1
Registered: ‎05-19-2010

Why does the power light continually flash green on AP135.

Why does the power light continually flash green on AP135? AP is plugged in to a cisco 2960 switch.  Does the port need to be configured a specific way for this access point?  The port works fine with an older Aurba ap.  The AP never shows up as an access point in the aruba admin tool.  Thanks

Aruba
Posts: 1,377
Registered: ‎12-12-2011

Re: Why does the power light continually flash green on AP135.

Is there a PoE setting on the port?  What is the power budget?  Is the AP rebooting?  

 

See this thread - http://community.arubanetworks.com/t5/Unified-Wired-Wireless-Access/Power-for-AP135/td-p/48440

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos
Occasional Contributor I
Posts: 8
Registered: ‎12-03-2012

Re: Why does the power light continually flash green on AP135.

Any chance you could capture the activity on the console port of the 135?  Seeing where it might be hanging up would be beneficial to troubleshooting this issue.

Super Contributor II
Posts: 354
Registered: ‎09-26-2012

Re: Why does the power light continually flash green on AP135.

There could be the reason that AP is not getting IP address..

Thanks & Regards
Syed Murad Ali
ACMP ACMA CCNA
Search Airheads
Showing results for 
Search instead for 
Did you mean: