Hi all,
I have some trouble getting ap-277's to work properly on a Cisco WS-C2960S-48FPS-L. I think it is the software version that is the problem, but I don't know for sure.
The problem is that the ap's don't advertise any radio because of LLDP not negotiating the POE settings.
Output of a "show ap debug system-status <ap-name> | begin "Power Status" " on the Local Controller:
Power Status
------------
Operational State POE-AF: Ethernet port 1 disabled; All radios disabled;
----------------- ------------------------------------------------------
Current HW State POE-AF: Ethernet port 1 disabled; All radios disabled;
LLDP Negotiated POE Power 0.0W
Output of "show lldp neighbor <interfacename> detail" som output has been blocked with ****:
Chassis id: ****
Port id: ****
Port Description: eth0
System Name: ****
System Description:
ArubaOS (MODEL: 277), Version 6.4.3.4 (51619)
Time remaining: 108 seconds
System Capabilities: B,W
Enabled Capabilities - not advertised
Management Addresses:
IP: ****
Auto Negotiation - supported, enabled
Physical media capabilities:
1000baseT(FD)
100base-TX(FD)
100base-TX(HD)
10base-T(FD)
10base-T(HD)
Media Attachment Unit type: 30
Vlan ID: - not advertised
Power via MDI:
Power Pair: Signal
Power Class: 4
Power Device Type: 2
Power Source: PSE
Power Priority: Unknown
Power Requested: 25500 mW
Total entries displayed: 1
I also have a AP-277 that does work. It is on another switch with a higher software version.
When I debug the LLDP traffic on the switch where the ap-277 does not work, I get the following messages in the log of the switch:
13333021: Dec 9 08:41:37.964 CET: LLDP unknown tlv type 127 recd - ignoring it
13333022: Dec 9 08:41:37.964 CET: LLDP malformed optional TLV 127 found - ignored
I don't get these messages on the switch where the ap-277 does work.
Any suggestions?