Wireless Access

Occasional Contributor I

design and implementing wifi aruba solution

Dear all, this is my first post at the Airheads and I hope this is the right place to be!!

I need to implement a wifi enterprise solution based on Aruba 105 Access Points.

I've already mounted the Airwave management system, but before the hype of starting installing the ap's I prefer to clarify some basics... I'm mainly concerned about security because the pilot zone where I need to start is just a 30 meters from the parking lot and I need to avoid the wireless signal to available there!!

Where do I start? What kind of info should I be aware of?

Tks in advance

Guru Elite

Re: design and implementing wifi aruba solution

The solution would be strong encryption like WPA2 Enterprise.


Please see "Building Global Security Policy for Wireless LANS" here:  http://www.arubanetworks.com/pdf/technology/whitepapers/wp_Global_security.pdf to start..

Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Re: design and implementing wifi aruba solution

Also, look over the wealth of information in our Validated Reference Design Guides, loads of good information contained within those.



Jerrod Howard
Sr. Technical Marketing Engineer
Occasional Contributor I

Re: design and implementing wifi aruba solution

thanks a lot for the hel, the document is a really good start for writing down some procedures!

Search Airheads
Showing results for 
Search instead for 
Did you mean: