Wireless Access

Reply
Occasional Contributor II
Posts: 14
Registered: ‎12-23-2011

per user session number

We have an Aruba controller in which we use sattefull firewal.

However since it keep sessions; in presence of a syn flood, the session table reaches its capacity and other users are not able to use the system untill the flood ends. Is there a way to limit the maximum sessions based on source IP.

 

MVP
Posts: 344
Registered: ‎07-26-2011

Re: per user session number

There might be a better way of doing this however I know you can limit the session limit based on the user role. This configures a maximum number of sessions per user in this role. The default is 65535. You can configure any value between 0-65535.

 

Configuration -> Access Control -> Security User Roles then edit the Max Sessions under the role.

ACMA, ACMP
If my post addresses your query, give kudos:)
Guru Elite
Posts: 20,819
Registered: ‎03-29-2007

Re: per user session number


onuryu wrote:

We have an Aruba controller in which we use sattefull firewal.

However since it keep sessions; in presence of a syn flood, the session table reaches its capacity and other users are not able to use the system untill the flood ends. Is there a way to limit the maximum sessions based on source IP.

 


Where is this syn flood coming from?  Is it coming from a user or external device?  

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 14
Registered: ‎12-23-2011

Re: per user session number

Hello

 

Both is possible.

Search Airheads
Showing results for 
Search instead for 
Did you mean: