Wireless Access

Reply
Occasional Contributor I

upgrade AMP to 7.7.10

Does anyone have steps for upgrading AMP firmware to 7.7.10? I am new to aruba and have never done a firmware update. how would i back up and revert to the a previous version if it fails? any help would be geatly appreciated thanks in advance.

Re: upgrade AMP to 7.7.10

It depends on your current version.  If it's 7.5 or above, ssh as "root" to the CLI.  You should have a root password which was created when AMP was installed initially. If you do not know it, open up a support case and they can assist.

 

In the cli, enter:

 

start_amp_upgrade -v 7.7.10

 

It will then prompt you for your support credentials and then start the upgrade.

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos
Frequent Contributor II

Re: upgrade AMP to 7.7.10

Do you have Master and failover ?
Occasional Contributor I

Re: upgrade AMP to 7.7.10

current version is 7.7.9, do i need to donwload the file first before running the cli command?

Re: upgrade AMP to 7.7.10

No - that commands will go grab it for you

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos
Moderator

Re: upgrade AMP to 7.7.10

Just to make it clear, the start_amp_upgrade command will grab the file only if your AMP has access to the internet.  You'll know if you have such access if you see the username and password prompt (this prompt is triggered by the support.arubanetworks.com site).

 

In a closed environment that doesn't have this access, then you'd have to download the upgrade package from the support site and then SCP it into /root (the start_amp_upgrade command looks for the file in /root by default -> if you choose a different location for the file, then you can use the '-f' flag to point to that directory).


Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company
Frequent Contributor II

Re: upgrade AMP to 7.7.10

Kyle

Attached you have the proccess I follow for my enviroment where we have a master and failover in diferent locations.  I've been using  this proccess since 7.6.4 above and it is working.  In my case,  I always start with my failover and stop the service until the new version in installed on the master to avoid the failover become the master and losing the license.

 

Hope this help.

 

Thanks,

Antonio

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: