Hi All,
I need some help with setting up PBR on the controller. Please could someone detail me what to do for PBR.I would need very basic instructions on what to do on the controller and what needs to be done on the network/core switch side of things.
I have not seen any Aruba documentation that details the basic configuration. All I have at the moment is two controllers talking to each other, AP’s are up and broadcasting SSIDs, but not working.
The setup at the moment is that there are two controllers in a master local scenario. They would like all http and https traffic directed at their smoothwall appliance. I tried to create a basic user role, which had any source to destination smoothwall on http and https, but this did not work.
This is the current setup of the BYOD network and I have no choice but to try and setup PBR, but it is not working:
BYOD configuration at the moment
The client connects authenticates against the NPS and falls into the authenticated role.
The client then gets a captive portal from the smoothwall. There is no CP is assigned in the controller.
This has generic HTTP and HTTPs allowed in there at the moment and other basic services for the client to get online.
The client gateway is on the core switch, which then has a default route to the smoothwall IP address. This is working as it is now.
BYOD Setup – What they want
The client connects authenticates against the NPS and falls into the authenticated role.
The client then gets a captive portal from the smoothwall. There is no CP is assigned in the controller.
They would like only http and https traffic directed directly at the Smoothwall.
I have tried to send destination http and https traffic to Smoothwall, but that does not work and the client cannot get out until you have http and https generic rule in there.
Please advise on how to do this.