Requirement:
Configuring a Broadcast Limit on the Switch
Broadcast-limit <0-99>
This is the maximum of network bandwidth in per cent that can be used for broadcast and multicast traffic. Any broadcast or multicast limit exceeding that limit will be dropped
Enables or disables broadcast limiting for outbound broadcasts on a selected port on the switch. The value selected is the percentage of traffic allowed, for example, broadcast-limit 5 allows 5% of the maximum amount of traffic for that port. A value of zero disables broadcast limiting for that port.
Switch to port context level before issuing the broadcast-limit command. This feature is not appropriate for networks requiring high levels of IPX or RIP broadcast traffic
HP-Switch-5406zl(config)# show interface brief a5
| Intrusion MDI Flow Bcast Port Type | Alert Enabled Status Mode Mode Ctrl Limit ------- --------- + --------- ------- ------ ---------- ----- ----- ------ B23 100/1000T | No Yes Up 1000FDx MDI off 0
HP-Switch-5406zl(config)# interface a5 broadcast-limit 20 | Intrusion MDI Flow Bcast Port Type | Alert Enabled Status Mode Mode Ctrl Limit ------- --------- + --------- ------- ------ ---------- ----- ----- ------ B23 100/1000T | No Yes Up 1000FDx MDI off 20
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.